|
December 21, 2008 00:12 AM  BY STACEY BARRUS
|
|
In today’s volatile and topsy-turvy
housing market, it’s not a bad idea to
add value to your home in new and innovative
ways.Don’t just think about renovating a
bathroom, consider using radiant
heaters to warm towel racks in the bathroom, or a
heated floor.Can you think of anything
cozier on a chilly winter morning than toasty
toes when you step out of the shower?
Not only is radiant heating is
one of the most comfortable ways to heat your
home, but radiant heaters also offer a surprisingly wide
diversity of applications. Radiant
heaters can be used in a number of applications,
including in tiled areas, hardwood flooring,
carpeted areas, cement floors, basements, and
garages.
Radiant
heaters are a type of heater that warms objects
instead of air. Radiant heat uses objects, such
as the floor, to heat a home. The air in the
room is warmed when it comes into contact with the
warmed objects. Heat loss is reduced and the
radiant heat remains in the lower part of the
room, warmer near feet level and slightly less so at
head level, creating the perfect climate for
comfort.
Radiant Heaters Tip:
The variety of high efficiency boilers or
electric radiant floor systems makes radiant
heat one of your most efficient ways to heat your home.
|
|
December 03, 2008 00:12 AM  BY STACEY BARRUS
|
|
|
When replacing a
home heating system, there are a lot of questions that
people have in regards to new home heating
systems. Here is a questions that was recently
asked.
Q: My 1,200
square foot home used to be heated by a furnace from 1949
that ran at 25,000 BTU. Recently I changed the system to a
newer, 7,000 BTU system. I thought this newer heater
would be more efficient, but I find that it takes much
longer to heat the house than the older system did. Is
there something wrong with my furnace or do I need one that
has a higher BTU?
A: It’s a good idea to replace old heating
systems with newer, more efficient models. These new
models can work just as well or better than old
systems, but they do work differently. Where old
furnaces could be turned on and heat the house within a
matter of minutes, new heating systems can take
longer. If you want your home to be warm at a certain
time, set the heat to go on about 45 minutes prior to that.
Another important factor is whether your home is
“weather-tight.” Make sure all doors and
windows are properly sealed. If not, you may be losing
heat at the same rate your heating system is producing it.
Check with a heating contractor who can tell you
whether the new unit is sized correctly for your
home’s square footage.
|
|
December 16, 2008 00:12 AM  BY STACEY BARRUS
|
|
With the high cost of heating fuels today, many
homeowners are wondering what other heating
options there are out there. Quite simply put,
radiant
heaters are the most efficient form of heat
available in today’s market.
Significantly less operating time is required to attain
and maintain the desired warmth compared to
furnaces and other, traditional methods of
heating, which keeps operational costs to a minimum.
High efficiency boilers or
electric radiant floor systems makes radiant
heat one of your most efficient ways to heat your
home. Combined with a well-insulated home these
systems can quickly warm your home and then shut
down or wait idle for long periods of time before being
called upon by the thermostat to operate.
More than ever before,
homebuilders, househunters, and home renovators
alike are looking for energy-efficient heating options
for houses. We say they need look no further
than radiant
heaters for their ideal home heating solution.
Radiant Heaters Tip: It might take a
little effort, but being more environmentally
friendly doesn’t have to involve major
renovations. Many people waste a lot of energy by not
sealing cracks, doors and windows. Checking to
make sure a home’s insulation is in good
shape and replacing it if it’s not is another
good surefire way to stop, prevent, and reverse
energy waste.
|
|
November 14, 2008 00:11 AM  BY STACEY BARRUS
|
|
|
If you’ve
been researching home
heating systems, chances are your head is
spinning right about now. It’s no wonder!
The number of types of radiant heaters available for
residences or businesses could make anyone dizzy in no time
at all. There’s really a lot of selection for
homeowners to choose from. Today we’ll discuss
the electric cable heating system kind of radiant
heaters. Electric cable heating systems are gaining
popularity in as radiant heaters and are ideal for
heating smaller areas (10-300 square feet) like
bathrooms, kitchens, and sun rooms. These systems are
comprised of a thermostat and a heating cable. On some
systems, the cable is be shipped as a large spool of
cable. These systems are oftentimes less expensive,
and give you the ability to space the cable how you want
and customize a layout that will heat every square inch of
your floor. Other systems have the cable attached to a
plastic mesh or tape to create a mat to maintain its
proper spacing.
Every available cable system is equally
effective, so when determining which radiant heater
system to purchase, you should look at the warranty of
the product, along with the ease of installation. Some
cables must be embedded in a separate layer of
concrete or mortar, whereas other systems can simply
be installed in the thinset.
Radiant Heaters Tip: When heating smaller
areas with a radiant heater, it is next to impossible
to beat the simplicity and price of an electric cable
heating system.
|
|
December 27, 2008 00:12 AM  BY STACEY BARRUS
|
|
When the first day of winter arrived over the
weekend, it brought along cold weather and the
potential for incredibly high heating bills.
Installing radiant
heaters in a home under construction or in an
existing home is proven to cut heating costs. It
works by putting water lines in the
home’s concrete floors or under existing floors
and running hot water through them.
Radiant
heaters help to keep the whole house at a more
constant temperature. In this way, our regular
heaters don’t have to do as much to keep
things warm and toasty during the winter. It might take
a little effort, but being more environmentally
friendly doesn’t have to involve major
renovations. Many people waste a lot of energy by not
sealing cracks, doors and windows. Checking to make sure
a home’s insulation is in good shape and
replacing it if it’s not is another good
way to stop energy waste.
Switching to radiant
heaters will not only help save energy, and lower
heating costs, but you’ll soon find that
it really adds to your family’s comfort as
well. That is because it put the heat at our feet, which
are generally cold, and offers cooler air near
head level, where we are generally a little
warmer.
Radiant Heaters Tip:
If you are looking for a great way to save
energy and maximize comfort in your home at the same
time, then radiant
heaters may be the perfect solution for you.
|
|
December 23, 2008 00:12 AM  BY STACEY BARRUS
|
|
|
For homeowners or
renovators, it’s worth taking a look at several kinds
of radiant heaters for residences or
businesses. Today we’ll discuss the electric
cable heating system kind of radiant heaters.
Electric cable heating systems, often called
line- or high-voltage systems, are gaining popularity
and are ideal for heating smaller areas like
bathrooms, kitchens, and sun rooms. These systems are
comprised of a thermostat and a heating cable. On some
radiant
heater systems, the cable will be shipped to
you as a large spool of cable. These systems are
oftentimes less expensive, and give you the ability to
space the cable how you want and customize a layout that
will heat every square inch of your floor. Other
systems have the cable attached to a plastic mesh or
tape to create a mat to maintain its proper spacing.
Every available radiant heater cable system is
equally effective, so when determining which system to
purchase, you should look at the warranty of the
product, along with the ease of installation. Some cables
must be embedded in a separate layer of concrete or
mortar, whereas other systems can simply be installed
in the thinset.
Most cable systems can only be installed under
tile; on others, if the cable is embedded in mortar or
concrete, any flooring can be installed on top of the concrete.
Radiant Heaters
Tip: When heating smaller areas with a radiant
heater, it is nearly impossible to beat the simplicity
and price of an electric cable heating system.
|
|
December 18, 2008 00:12 AM  BY STACEY BARRUS
|
|
The home improvement world has seen many recent
developments in heating, making hydronic systems
more convenient and possible radiant
heater solutions for major home remodeling projects.
Today we’re going to discuss one form of
radiant
heaters: hydronic floor heating.
Hydronic floor heating is the
oldest and most popular type of radiant
floor heating. These systems are comprised of a
boiler or hot water heater, pumps, manifolds,
PEX tubing, thermostat, and either gypcrete (a
concrete-like material) or wood panels. Hydronic heating
is the most complex of all radiant heat systems.
These systems require trained professionals to
design and perform the installation. Your best
economies of scale are achieved for hydronic systems in
large areas or entire homes because of their
expensive components and operational costs.
Hydronic systems can be installed under any type of
flooring.
Most hydronic systems require
hot water tubing to be installed in a
2-4″ bed of light concrete and are best installed
during the initial construction because of its
weight load demands and adjustments to floor
height.
If you’re wanting to
heat smaller areas such as a bathroom or kitchen,
a hydronic floor radiant
heating system may not be the best value for your
project. The complexity and cost of installing
the system, along with the long-term maintenance
and up-keep required, might not be worth the small
amount you will save in operational costs.
Radiant Heaters Tip:
Radiant
heaters for your home or business come in a variety
of forms – all efficient and providing
reliable, cozy warmth
|
|
December 25, 2008 00:12 AM  BY STACEY BARRUS
|
|
|
As demands for
lower energy costs increase, homebuilders, househunters,
and home renovators alike are looking for energy-efficient
heating options for houses. We say they need
look no further than radiant
heaters for their ideal home heating solution.
In a nutshell, radiant
heating is among the most efficient forms of heat
available in today’s market. Significantly less
operating time is required to attain and maintain the
desired warmth compared to furnaces and other,
traditional methods of heating, which keeps operational
costs to a minimum.
High efficiency boilers or electric radiant
floor systems makes radiant heat one of your most
efficient ways to heat your home. Combined with a
well-insulated home, these radiant heater systems can
quickly warm your home and then shut down or wait idle
for long periods of time before being called upon by
the thermostat to operate.
Radiant Heaters
Tip: Being more environmentally friendly
doesn’t have to involve major renovations. Many
people waste a lot of energy by not sealing cracks, doors
and windows. Checking to make sure a home’s
insulation is in good shape and replacing it if
it’s not is another good surefire way to stop,
prevent, and reverse energy waste.
|
|
December 19, 2008 00:12 AM  BY STACEY BARRUS
|
|
|
Sometimes can be
hard to narrow down what kind of radiant
heaters to install. There are dozens of products
available to purchase, and there are even more
companies telling you that their product is the best.
For many homeowners, electric cable heating systems,
often called line- or high-voltage systems, are
gaining popularity and are ideal for heating smaller
areas like bathrooms, kitchens, and sun rooms. These systems
are comprised of a thermostat and a heating cable.
These radiant
heater systems are oftentimes less expensive,
and give the ability to customize a layout that will
heat every square inch of your floor.
Every available radiant heater cable system is
equally effective, so when determining which system to
purchase, you should look at the warranty of the
product, along with the ease of installation. Some cables
must be embedded in a separate layer of concrete or
mortar, whereas other systems can simply be installed
in the thinset. Most radiant heater cable systems can
only be installed under tile. However, on others, if the
cable is embedded in mortar or concrete, any flooring
can be installed on top of the concrete.
Radiant Heaters Tip: When heating smaller
areas, it is nearly impossible to beat the simplicity
and price of an electric cable radiant heating
system.
|
|
December 24, 2008 00:12 AM  BY STACEY BARRUS
|
|
You may not know that radiant
heaters for your home or business come in a variety
of forms – all efficient and providing
reliable, cozy warmth. Today we’re going to
discuss one form of radiant heaters: hydronic floor
heating.
Quite a name, isn’t it?
Hydronic floor heating is the oldest and most
popular type of radiant floor heating. These systems are
comprised of a boiler or hot water heater,
pumps, manifolds, PEX tubing, thermostat, and
either gypcrete (a concrete-like material) or wood
panels. Hydronic heating is the most complex of
all radiant
heat systems. These systems require trained
professionals to design and perform the
installation. Your best economies of scale are achieved
for hydronic systems in large areas or entire homes
because of their expensive components and
operational costs. Hydronic systems can be
installed under any type of flooring. Most hydronic
systems require hot water tubing to be installed
in a 2-4″ bed of light concrete and are
best installed during the initial construction because
of its weight load demands and adjustments to
floor height.
For heating smaller areas such
as a bathroom or kitchen, a hydronic floor
heating system may not be the best value for your
project. The complexity and cost of installing
the system, along with the long-term maintenance
and up-keep required, might not be worth the small
amount you will save in operational costs.
Radiant Heaters Tip: Many recent
developments have made hydronic systems more
convenient and possible radiant
heater solutions for major home remodeling projects.
|
|
|